;Rev. 01 06/30/93 AdapterId 06795h AdapterName " NeoTecH Single RS-422/485 Async. Adapter, S1M200" NumBytes 3 NamedItem Prompt "Port Address" choice "SERIAL_2 (02f8h)" pos[1]=11111XXXb pos[2]=00000010b io 02f8h-02ffh choice "SERIAL_3 (3220h)" pos[1]=00100XXXb pos[2]=00110010b io 3220h-3227h choice "SERIAL_4 (3228h)" pos[1]=00101XXXb pos[2]=00110010b io 3228h-322fh choice "SERIAL_5 (4220h)" pos[1]=00100XXXb pos[2]=01000010b io 4220h-4227h choice "SERIAL_6 (4228h)" pos[1]=00101XXXb pos[2]=01000010b io 4228h-422fh choice "SERIAL_7 (5220h)" pos[1]=00100XXXb pos[2]=01010010b io 5220h-5228h choice "SERIAL_8 (5228h)" pos[1]=00101XXXb pos[2]=01010010b io 5228h-522fh choice "SERIAL_1 (03f8h)" pos[1]=11111XXXb pos[2]=00000011b io 03f8h-03ffh Help "This port can be assigned to Serial 1-8. Use F5=Previous and the F6=Next keys to change serial port assignments if you are in the 'Change configuration' window. Conflicting assignments are marked with an asterisk and must be changed to use the adapter." NamedItem Prompt "Interrupt Level" choice "Int 3" pos[0]=XXXXX11Xb int 3 choice "Int 4" pos[0]=XXXXX10Xb int 4 choice "Int 7" pos[0]=XXXXX01Xb int 7 choice "Int 9" pos[0]=XXXXX00Xb int 9 Help "This port can be assigned to Interrupt level 3, 4, 7, or 9. Use F5=Previous and the F6=Next keys to change serial port assignments if you are in the 'Change configuration' window. Conflicting assignments are marked with an asterisk and must be changed to use the adapter." NamedItem Prompt "Transmitter Driver Control" choice "RS-422 (always enabled)" pos[0]=XXX11XXXb choice "RS-485 (enabled by RTS)" pos[0]=XXX01XXXb choice "RS-485 (enabled by DTR)" pos[0]=XXX10XXXb choice "Always DISABLED " pos[0]=XXX00XXXb Help "This port may be defined as RS-422 or RS-485. RS-422 is most commonly used in a four wire, full duplex mode (2 devices). RS-485 is used in a two or four wire half duplex mode with a 'bus' type architecture. Either the DTR signal or RTS signal may be used to control the line drivers. Use F5=Previous and the F6=Next keys to change serial port assignments if you are in the 'Change configuration' window."