; It is NOT recommended to use this file as anything other than a TEMPLATE
; to get your DE-320 working under the MNC3 for DOS. Setup should populate
; most of these values.

[network.setup]
version=0x3110
netcard=ms$ne2clone,1,MS$NE2CLONE,1
transport=tcpip,TCPIP
lana0=ms$ne2clone,1,tcpip

[MS$NE2CLONE]
INTERRUPT=3       ; remove any I/O address line presented here - you're dealing with an MCA bus, remember?
                  ; you can leave the IRQ setting in place if it's correct
DriverName=DE320$ ; this must read 'DE320$' or nothing will work
[TCPIP]           ; I am using TCP/IP and assume you're doing the same
NBSessions=6
DefaultGateway0=  ; specify your default gateway here - no dots are used between octets!
SubNetMask0=      ; specify your subnet mask here - again, no dots between octets!
IPAddress0=       ; specify your workstation's IP address - no dots!
DisableDHCP=1     ; change to zero and leave the above values blank if using DHCP
DriverName=TCPIP$
BINDINGS=MS$NE2CLONE
LANABASE=0
[protman]
DriverName=PROTMAN$
PRIORITY=MS$NDISHLP